These are clamps for the prusa i3 mk2/3 for transport. They will fix the belts and the Z-Axis. This is a remix of the original prusa transportation clips.

Note "Z-axis nut" is also needed for X-Axis fix

Additional hardware:

3x M3x20 cylinder head screws
3x M3 square nuts

Call it the End-Fedz Trail Friendly killer if you like. This thing is much smaller and lighter, and a perfect match for the Mountain Topper series radios when you build in some traps or links.

Needed Materials:

• Special BNC connectors: https://amzn.to/38riPF7
• Toroids for this project are FT50-43: https://amzn.to/2NU7vbc
• Capacitors are 100 pF SMD ceramic 500V or 1kV models.
• 28 ga magnet wire: https://amzn.to/2AyjpEI
• Poly-Stealth 26 ga antenna wire. I've ordered from this company a few times and had great service: https://www.amateurradiosupplies.com/...
• 5 minute epoxy: https://amzn.to/2ZAAFRZ
• 5/8" or 3/4" heat shrink tubing (adhesive lined preferred): https://amzn.to/2VK5Rgq
• 3/32" or 1/8" heat shrink tubing: https://amzn.to/2NTnKFp